▶
Insert the key ring into the slot on the server rear (1).
▶
T
urn the key ring clockwise by 90
degrees (2) until it latches in place as
shown (3).
4.6 Connecting the power cord
4.6.1 Connecting the power cord (standard PSU)
CAUTION
The server automatically adjusts to a mains voltage in the range from
100 V - 240 V
.
▶
You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
▶
Connect the power cord to the PSU.
▶
Connect the mains connector to a grounded mains outlet in the in-house
power supply network.
Figure 35: Securing power cord
Basic hardware procedures
TX1330 M4 Upgrade and Maintenance Manual 79
To Next Page
Loading...
