▶
"Switching on the server" on page 81
.
12.5 Replacing accessible drives
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver (for installing mounting
brackets)
Preliminary steps
▶
"Locating the defective server" on page 45
.
▶
"Removing backup and optical disk media" on page 102.
▶
"Verifying and configuring the backup software solution" on page 102.
▶
"Shutting down the server" on page 47.
▶
"Disconnecting the power cord" on page 48.
▶
"Getting access to the component" on page 50.
Removing the front cover is not required in order to replace an
accessible drive. The front cover only needs to be removed in order to
remove or install accessible drive dummy covers and this is not
necessary here.
Removing the defective accessible drive
▶
Remove the accessible drive, see "Removing an accessible drive" on
page
370
.
Installing the new accessible drive
▶
Install the accessible drive, see "Installing an accessible drive" on page 366.
▶
Connect all cables to their original accessible drive connectors, see
"Appendix B" on page 519.
Accessible drives
372 Upgrade and Maintenance Manual TX1330 M4
To Next Page
Loading...
