For more information on how to resume BitLocker drive encryption, see
the Microsoft TechNet library at:
https://technet.microsoft.com/library/cc731549.aspx
For more information, see the Fujitsu web pages.
5.3.15 Performing a RAID array rebuild
After replacing an HDD that has been combined into a RAID array, RAID
rebuild will be performed completely unattended as a background process.
▶
Ensure that the RAID array rebuild has started normally
. Wait until the
progress bar has reached at least one percent.
▶
Inform the customer about the remaining rebuild time, based on the
displayed duration estimate.
Figure 55: Progress bar (RAID array rebuild)
CAUTION
The system is now operational, however, data redundancy will not be
available until the RAID array rebuild is complete. Depending on the
HDD capacity the overall process can take up to several hours, in some
cases even days.
Basic software procedures
122 Upgrade and Maintenance Manual TX1330 M4
To Next Page
Loading...
