Fujitsu PRIMERGY TX1330 M4

Removing a 2.5-inch HDD/SSD dummy module
Figure 123: Removing a 2.5-inch HDD/SSD dummy module
▶
Press both tabs together (1) and pull the dummy module out of its bay (2).
CAUTION
▶
Keep the dummy module for future use.
▶
Always replace dummy modules into unused HDD/SSD bays to
comply with applicable EMC regulations and satisfy cooling
requirements.
Installing a 2.5-inch HDD/SSD module
Figure 124: Opening the locking lever
▶
Pinch the green locking clips (1) and open the locking lever (2).
Hard disk drive (HDD) / solid state disk (SSD)
TX1330 M4 Upgrade and Maintenance Manual 215