Fujitsu PRIMERGY TX1330 M4

▶
"Disconnecting the power cord" on page 48
.
▶
"Getting access to the component" on page 50.
▶
Remove the system fan module, see "Removing the system fan module" on
page 82.
Removing a memory module
Figure 215: Removing memory modules (A)
▶
Eject the desired memory module by pressing out the securing clips at each
end of the memory slot.
Figure 216: Removing memory modules (B)
▶
Remove the ejected memory module.
Concluding steps
▶
Install the system fan module, see "Installing the system fan module" on
page
85
.
▶
"Reassembling" on page 66.
▶
"Connecting the power cord" on page 79.
▶
"Switching on the server" on page 81.
▶
"Resuming BitLocker functionality" on page 121.
Main memory
TX1330 M4 Upgrade and Maintenance Manual 337