○○○○○○○○○○○○○○○○○○○○○○
Quick Guide 1•9
○○ ○○○○○○○○○○○○○○○○○○○○
Quick Guide 1•9
Getting to know your instrument
POWER UP
1. Connect the audio cables
Connect the stereo audio outputs (Left, Right)
to your amp. system (mixer, powered speak-
ers, etc.) using audio cables with standard 1/
4” jacks. Use RCA jacks to connect to do-
mestic stereo units. For mono reproduction,
connect to either the Left or Right jack.
2. Insert the instrument’s power cord into a
suitable grounded wall outlet and press the
power switch to turn on SK760/880SE.
After a few seconds the instrument will set to
the default situation.
The initial (default) main display screen will
show a single sound (GrandPiano1) active.
3. If necessary, regulate the display contrast
with the DISPLAY CONTRAST panel knob on
the left of the display.
Different viewing angles may require an ad-
justment of the display contrast.
4. Play on the keyboard and you will hear a
piano sound (GrandPiano 1) play across the
full keyboard.
5
<---------------------------- FULL keyboard ------------------------->
○○○○○○○○
If you are using external
amplification, better
results are obtained by
adjusting the volume
with mixer or amplifier
controls rather than
lowering the volume of
○○○○○○○○
the instrument.
2
3
4
1
○○○○○○○○○○○○○○○○○○○○
N.B. Remember that the SK760/880SE does not have
internal speakers, therefore you must either connect to
an external amplification system, or use a set of stereo
○○○○○○○○○○○○○○○○○○○○
headphones.
ADJUST THE GENERAL VOLUME
5. Adjust the general volume with the MASTER
VOLUME slider.
A comfortable level is around two thirds of
the slider’s travel distance.
Getting to know your instrument
POWER UP
1. Connect the audio cables
Connect the stereo audio outputs (Left, Right)
to your amp. system (mixer, powered speak-
ers, etc.) using audio cables with standard 1/
4” jacks. Use RCA jacks to connect to do-
mestic stereo units. For mono reproduction,
connect to either the Left or Right jack.
2. Insert the instrument’s power cord into a
suitable grounded wall outlet and press the
power switch to turn on SK760/880SE.
After a few seconds the instrument will set to
the default situation.
The initial (default) main display screen will
show a single sound (GrandPiano1) active.
3. If necessary, regulate the display contrast
with the DISPLAY CONTRAST panel knob on
the left of the display.
Different viewing angles may require an ad-
justment of the display contrast.
4. Play on the keyboard and you will hear a
piano sound (GrandPiano 1) play across the
full keyboard.
5
<---------------------------- FULL keyboard ------------------------->
○○○○○○○○
If you are using external
amplification, better
results are obtained by
adjusting the volume
with mixer or amplifier
controls rather than
lowering the volume of
○○○○○○○○
the instrument.
2
3
4
1
○○○○○○○○○○○○○○○○○○○○
N.B. Remember that the SK760/880SE does not have
internal speakers, therefore you must either connect to
an external amplification system, or use a set of stereo
○○○○○○○○○○○○○○○○○○○○
headphones.
ADJUST THE GENERAL VOLUME
5. Adjust the general volume with the MASTER
VOLUME slider.
A comfortable level is around two thirds of
the slider’s travel distance.