UTILITY
147
Copy From USB Setting
Copy the parameters settings from the
connected USB to GPT-9500. It is noted that
only USB1.1 or 2.0, FAT16 or FAT32, capacity
<= 64G can support this function.
1. Press the UTILITY key on the front
panel followed by using the scroll
wheel to move to the Copy From
USB. Press the ENTER soft-key to
enter the Copy From USB field.
2. Use the scroll wheel to move to
target .SAV file within the USB
followed by pressing OK soft-key
to proceed to the next step.
3. Use the scroll wheel to move to
each check box followed by
pressing the PAGE key to
check/uncheck each parameter.
To Next Page
Loading...
Need help?
General
