186
Installation
Remove the factory-delivered sensor of Tow from original
( )
( )(
)
（ ）
(
-supplied）
Fixing the sensor
1. Fix the sensor with insulating aluminum tape
transference.
Make good contact between sensor and pipe.
Most sensitive
point of the sensor
Maximize the
contact
2.
in order to avoid loosening of the sensor after some
years.
3.
4. Insulate the sensor with the insulation sheet
In case that the sensor supplied with unit is not long enough, please
make sure that the length extension is properly done avoiding
the sensing distortion and that the joint is properly insulated and
waterproof to avoid any electrical failure.
To Next Page
Loading...
