Honeywell UDC2800 - Security and Lockout

176
Entering a Security Code
Introduction
The level of keyboard lockout may be changed in the Setup mode.
However, knowledge of a security code number (0 to 9999) may be
required to change from one level of lockout to another. When a
controller leaves the factory, it has a security code of 1234 which
should be entered and changed after the first power up or after
restoring to factory default settings.
Procedure
If you require the use of a security code, select a number from 0001
to 9999 and enter it when the lockout level is configured as
None.Thereafter, that selected number must be used to change the
lockout level from something other than None.
ATTENTION: Write the number on the Configuration Record
Sheet in the configuration section so you will have a
permanent record.
Step Operation Press Result
1 Enter Setup
Mode
Setup key The first set up group is Security.
2 Select the
function prompt
Password
Function key Enter into the first function prompt
Password of the Security set up group.
Press the Function key again to enter in the
configuration prompt of Password.
3 Enter Security
Code
Increment key
or Decrement
key
To enter a four digit number (0001 to 9999)
This will be your security code.
ATTENTION: Users must be careful
while entering the password as the
password is not hidden.
Chapter 5 - Monitoring and Operating the Controller