Honeywell UDC2800 User Manual

CHAPTER
10
CONFIGURATION VIA HONEYWELL
EASYSET
Honeywell EasySet app lets users configure their instrument on a
Mobile Device via Bluetooth. It is available to detect and connect
controllers within 3 meters.
This app can be installed on IOS 12.0 or higher operating system.
NOTE: The R100 UDC device does not support the latest
Honeywell EasySet app. Users must upgrade their UDC device
firmware to the R110.2 version to use the app.
NOTE: It is recommended to use the Honeywell EasySet app on 5
inch and abovescreen size iOS mobiles for a better experience.
The configurations are accessed using icons introduced below.
Figure 10-1: Honeywell EasySet interface
282

Honeywell UDC2800 Specifications

General

Control Modes	PID, ON/OFF, Manual
Mounting	Panel Mount
Display	Dual 4-digit LED
Input Types	Thermocouple, RTD, mA, mV, V
Output Types	Relay
Power Supply	100-240 VAC, 50/60 Hz
Communication	RS-485 Modbus RTU
Enclosure Rating	NEMA 4X