Honeywell UDC2800 - Input Setup Group

Input 1 Set Up Group
Introduction
This data deals with various parameters required to configure Input
1.
Function Prompts
Table 4-10: INPUT 1 Group Function Prompts
Function
Prompt
Selections or
Range of Setting
Parameter Definition
Input 1 Type Input 1 Actuation Type – This selection determines
what actuation you are going to use for Input 1.
See Minimum and Maximum Range Values for
more information.
ATTENTION: Changing the input type will
result in the loss of Field Calibration values
and will restore Factory Calibration values.
Disable Disables Input
TC B B Thermocouple
TC E High E Thermocouple High
TC E Low E Thermocouple Low
TC J High J Thermocouple High
TC J Mid J Thermocouple Med
TC J Low J Thermocouple Low
TC K High K Thermocouple High
TC K Mid K Thermocouple Med
TC K Low CK Thermocouple Low
TC M High M Thermocouple High (Ni-Ni-Moly)
TC M Low M Thermocouple Low (Ni-Ni-Moly)
115
Chapter 4 - Configuration