Honeywell UDC2800 User Manual

126
Function
Prompt
Selections or
Range of
Setting
Parameter Definition
ATTENTION: The Thermocouple Health
feature is disabled when NO FS is configured.
Control Set Up Group
Introduction
The functions listed in this group deal with how the controller will
control the process including: Number of Tuning Parameter Sets,
Setpoint Source, Tracking, Power-up Recall, Setpoint Limits, Output
Direction and Limits, Deadband, and Hysteresis.
Function Prompts
Table 4-12: CONTROL Group Function Prompts
Function
Prompt
Selections or Range
of Setting
Parameter Definition
PV Source Process Variable Source - Selects the source of
the Process Variable.
Input 1 Input 1
Input 2 Input 2
Input Algorithm 1 Input Algorithm 1
PID Sets Number of Tuning Parameter Sets- This selection
lets you choose one or two sets of tuning
constants (gain, rate, and reset).
NOTE: The Tuning Group is
automatically configured to have two
PID sets when a Duplex Control
Algorithm is configured
Chapter 4 - Configuration

Honeywell UDC2800 Specifications

General

Control Modes	PID, ON/OFF, Manual
Mounting	Panel Mount
Display	Dual 4-digit LED
Input Types	Thermocouple, RTD, mA, mV, V
Output Types	Relay
Power Supply	100-240 VAC, 50/60 Hz
Communication	RS-485 Modbus RTU
Enclosure Rating	NEMA 4X