Honeywell UDC2800 - SP Program 8

406
SP Program 8
Table 12-20: Setpoint Program 8
Parameter Description
Register Address
Access Description
Hex Decimal
SP Program Output 1E70 47793 R Setpoint
Program output
value
(engineering
unit)
Current Segment Number
1E72 47795 R Floating Point;
1...Max
Segment #
A write changes
the segment
number
Segment Time Remaining 1E78 47801
R Floating Point
in Seconds or
Time Units
Status 1E7B 47804
R Bit 0: 1=Ready
1: 1=Run
2: 1=Hold
3: 1=End
4: 1=Time Units
in Seconds
5: 1=Time Units
in Minutes
6: 1=Time Units
in Hours
7: Ramp Units
l
0: Time
l
1: Rate
Chapter 12 - Standard Modbus Read, Write and Override Parameters