Honeywell UDC2800 - Configuration Record Sheet

Auxiliary Calib Set Up Group
Introduction
This group appears when Auxiliary Output of Options set up group is
NOT configured as Disable. See Options Set Up Group for more
information.
Function Prompts
Table 4-21: Auxiliary Calib Group Function Prompts
Function Prompt
Selections or Range of
Setting
Parameter Definition
Zero Value It ranges from 0 to
65535.
The desired 0 % output is read on the
milliammeter. Normally, this will be
the setting that produces 4 mA.
Span Value It ranges from 0 to
65535.
The desired 100 % output is read on
the milliammeter. Normally, this will
be the setting that produces 20 mA.
Configuration Record Sheet
Enter the value or selection for each prompt on this sheet so you will
have a record of how your controller was configured.
Group
Prompt
Function
Prompt
Value or
Selection
Factory Setting
Security Password
Lockout
Auto/Man Key
Run/Hold Key
SP Select Key
Restore Settings
Restore*
Change Password
__________
__________
__________
__________
__________
__________
__________
__________
0
Calibration
Enable
Enable
Enable
Disable
Disable
- -
Tuning Proportional Band 1
or
__________
__________
- -
167
Chapter 4 - Configuration