Security Set Up Group
Introduction
Security enables you to configure lockout, password, restore the
product, and we recommend that you configure this group last, after
all other configuration data has been loaded.
ATTENTION: Users must be careful while entering the
password as the password is not hidden.
ATTENTION: It is recommended to change the password after
each use.
Function Prompts
Table 4-3: Security Group Function Prompts
Function
Prompt
Selections or
Range of
Setting
Parameter Definition
Password 0000 to 9999 The level of keyboard lockout may be changed in the
Set Up mode. Knowledge of a password may be
required to change from one level to another. This
configuration should be copied and kept in a secure
location.
NOTE: The default password for the UDC
device is 1234. It is recommended to change
the password after the first login.
NOTE: The password is for keyboard entry only
and is not available via communications.
NOTE: Holding both the Increment and
Decrement keys while editing numerical values
in the main or setup screen allows the current
editable digit to move one step left.
73
Chapter 4 - Configuration
To Next Page
Loading...
Need help?
General
