Honeywell UDC2800 - Page 74

74
Function
Prompt
Selections or
Range of
Setting
Parameter Definition
ATTENTION: If the password is not correct, the
following prompts cannot be displayed except
Restore Settings.
Lockout Lockout applies to one of the functional groups:
Configuration, Calibration, Tuning, Accutune.
ATTENTION: Do not configure it until all
configuration is complete.
NOTE: In the Honeywell EasySet app, lockout
options appears under the security group only
after entering the password.
None No lockout; all groups are read/write.
Calibration All groups are available for read/write except for the
Calibration and Keyboard Lockout groups.
+ Configuration Tuning, SP Ramp, and Accutune groups are
read/write. All other groups are read only. Calibration
and Keyboard Lockout groups are not available.
+ View Tuning and Setpoint Ramp parameters are
read/write. No other parameters are viewable.
Max Tuning and Setpoint Ramp parameters are available
for read only. No other parameters are viewable.
Auto/Man
Key
Allows you to disable the Auto/Manual Key
Disable Disable the Auto/Manual Key
Enable Enable the Auto/Manual Key
ATTENTION: Can only be viewed if Lockout is
configured for None.
Chapter 4 - Configuration