EasyManuals Logo

Honeywell UDC2800 User Manual

Honeywell UDC2800
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #274 background imageLoading...
Page #274 background image
Step What to do How to do it
5 Change Auxiliary
Output board.
Installation instructions provided with new board.
6 Change Controller
Restoring Factory Configuration
Introduction
This procedure restores the configuration of the instrument back to
the Factory Settings. See Configuration Record Sheet for more
information.
ATTENTION: Restoring the factory configuration overwrites all
user-entered configuration changes. This procedure cannot be
undone, it is a one-way process.
Table 8-15: Restoring Factory Configuration
Step Operation Press Result
1 Enter
Security set
up group
Setup key Enter into the Setup mode.
Setup key or
Increment key or
Decrement key
Until you see Security.
2 Enter
Security Code
Function key Enter into the first function prompt
Password of Security set up group.
Press the Function key again to the
password configuration.
Increment key or
Decrement key
Enter the correct password.
ATTENTION: Users must be
careful while entering the
password as the password is not
hidden.
274
Chapter 8 - Troubleshooting/Service

Table of Contents

Other manuals for Honeywell UDC2800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell UDC2800 and is the answer not in the manual?

Honeywell UDC2800 Specifications

General IconGeneral
Control ModesPID, ON/OFF, Manual
MountingPanel Mount
DisplayDual 4-digit LED
Input TypesThermocouple, RTD, mA, mV, V
Output TypesRelay
Power Supply100-240 VAC, 50/60 Hz
CommunicationRS-485 Modbus RTU
Enclosure RatingNEMA 4X

Related product manuals