HP 8753E - In Case of Difficulty; Test Port 1 Magnitude Compression; Test Port 2 Magnitude Compression

l4- At the end of the sweep, press [mf) ,~~~~~~~.
,.::::.:: . . . . . . . . . . . . . . . . . ..~.....~ .
. . ..A ..>.a>: . . . . . . . . . . . . . . . .A.. s . . . . ..i. >>>>.
17. Write the absolute value of marker 2 in the “Performance Test Record. n
18. Repeat steps 12 through 17 for the other frequencies listed for Port 2 on the
“Performance Test Record. n
Test Port 1 Magnitude Compression
. . . . . . . . . . . . . . . . . . . . . . ..~~................. ,:::::: .::::::
:::.::
19. Press (Meas) ~~~~~~~~~~~ :;~,~~~~.~~~~~~~.
20- Press B i&ii+. 3!J#.iJQ~~ [sol (TiJiJ
.._.._.... - -
25. Write the absolute value of the marker 2 reading in the “Measured Value”
column of the “Performance Test Record. n
26. Repeat steps 20 through 25 for the other CW frequencies listed for Port 1 in
the “Performance Test Record.”
In Case of DifIkulty
1. If the analyzer fails “Test Port 2 Magnitude Compression”:
a. Repeat this test.
b. Replace the A6 B sampler assembly if the analyzer stiII fails the test.
2. If the analyzer fails “Test Port 1 Magnitude Compression”:
a. Repeat this test.
b. Replace the A5 A sampler assembly if the analyzer stiII fails the test.
System Verification and
2-81
Performance Tests