HP 8753E - Port 1 Input Worst Case 2 Ndharmonic

Port 1 Input Worst Case 2nd Harmonic
19. Connect the equipment as shown in Figure 2-45.
HP 8753E
NETWORK ANALYZER
-
I I
-
PORT 1
PORT 2
I I
CABLE APC-7
sg630e
Fiiure Z-45. Eeceiver Harmonics lkst Setup
22. Press m (16) m m @ Lc/n to set the frequency range.
. . . . . . . . . . . ., . . ..~...:.:.:.:.~.:.:. ‘:.:.:.:...:.:.:...:,:~:::.:~.,:.:..::~,,:,,
24. After one sweep, press m ~~~~~~~~~~~ ~~~~~~~ to nom&e the
-..... _ .~..................... ____..i . . . . . . .i_ .. . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -SW . . . . . . 2:: . . . . . . 3: . ...=... i....~...............
trace.
26. After one sweep, press Cm. ~~~~~~~~~~ to get a better tiewing of the
A . . . . . . . . . . . . . . . . . . .. ,..,.. . ..: ,,..A/ . . . . . ... i.l.z:>;>
trace.
28. Write the marker 1 value (which appears on the analyzer display) on the
‘Performance Test Record.” This is the worst case port 1 input (receiver
channel A) 2nd harmonic
2-l 04 Systam Verification and
Performanw Tests