Device Verification
33. At the prompt, connect the 20
dI3
attenuator (supplied in the verification
kit) as shown in Figure 2-4.
,..
If you switched OFF the record function, you have to press
~~~~~
..,
,....
,...................
after each S-parameter measurement.
If you switched ON the record function, the analyzer measures all
S-parameters (magnitude and phase) without pausing. Also, the analyzer
only displays and prints the PASS/FAIL information for the S-parameter
measurements that are valid for system verification.
HP
R753F
.
.
.
-.
---
NETWORK ANALYZER
/
Figure 2-4. Connections for the 20
dB
Verification Device
35. When the analyzer fmishes all the measurements, connect the 50
dB
attenuator (supplied in the
vetication
kit), as shown in
F’igure
2-5.
2-14
System Verification and
Performance Tests
To Next Page
Loading...
