Assembly Replacement Sequence
The following steps show the sequence to replace an assembly in an HP 8753E
network analyzer.
1. Identify the faulty group. Refer to Chapter 4, “Start Troubleshooting Here.”
Follow up with the appropriate troubleshooting chapter that identifies the
faulty assembly.
2. Order a replacement assembly. Refer to Chapter 13, “Replaceable Parts.”
3. Replace the faulty assembly and determine what adjustments are necessary.
Refer to Chapter 14, “Assembly Replacement and Post-Repair Procedures.
n
4. Perform the necessary adjustments. Refer to Chapter 3, “Adjustments and
Correction Constants.
n
5. Perform the necessary performance tests Refer to Chapter 2, “System
Verification and Performance Tests
’
5-2 Power Supply Troubleshooting
To Next Page
Loading...
