HP 8753E - Page 27

Tables
l-l. Required Tools
........................
l-l
l-2. Service Test Equipment
...................
l-2
l-3. Connector Care Quick Reference
...............
l-6
2-l. Magnitude Dynamic Accuracy Calculations ..........
2-79
3-l. Related Service Procedures
..................
3-2
3-2. PEEK/POKE Addresses
....................
3-60
5-l. A8 Post Regulator Test Point Voltages .............
5-6
5-2. Output Voltages
.......................
5-10
5-3. Recommended Order for RemovaYDiscoMection ........ 5-12
5-4. Recommended Order for RemovaVDiscoMection ........ 5-18
6-l. Front Panel Key Codes
.................... 6-14
6-2. Internal Diagnostic Test with Commentary ........... 6-18
7-l. Output Frequency in SRC Tune Mode ............. 7-8
7-2. Analog Bus Check of Reference Frequencies .......... 7-13
7-3. Al2 Reference Frequencies
..................
7-15
7-4. AlX-Related Digitd Control SiiaIs ..............
7-23
7-5. VCO Range Check Frequencies
................
7-25
7-6. A14to-A13 Digital Control Siiai Locations .......... 7-30
7-7. 1st IF Waveform Settings
...................
7-35
7-8. All Input Signals
......................
7-36
8-l. SiiaIs Required for A10 Assembly Operation ......... 8-9
8-2. 2nd IF (4 kHz) Siiai Locations
................
8-11
8-3. 2nd LO Locations
......................
8-14
9-l. Components Related to Specific Error Terms ..........
94
10-l. Test status Terms
......................
10-4
11-l. Calibration Coefficient Terms and Tests
............
11-7
1 l-2. Uncorrected System Performance
...............
11-9
12-1. Super Low Band Subsweep Frequencies ............
12-15
12-2. Low Band Subsweep Frequencies
...............
12-18
12-3. High Band Subsweep Frequencies
...............
12-21
12-4. Mixer Frequencies
...................... 12-30
13-1. Reference Designations, Abbreviations, and Options ......
1348
14-1. Related Service Procedures
..................
1462
Contents-22