HP 8753E - Page 431

6.
To measure the standard, when the displayed trace has settled, press:
7.
8.
The analyzer underlines the Bi&$i. softkey after it measures the standard.
.- .._...............
Disconnect the open, and connect a short circuit to PORT 1.
To measure the device, when the displayed trace has settled, press:
: s.. ::::::z.: . . . . .
. . ..i .::::...::.r
The analyzer underlines the ~~~~~~ softkey after it measures the standard.
9.
10.
11.
12.
13.
14.
Disconnect the short, and connect an impedance-matched load to PORT 1.
lb measure the standard, when the displayed trace has settled, press:
y ::. . . p
.vy<
The analyzer tmderlines the :&&I& softkey after it measures the standard.
Repeat the open-short-load measurement descried above, but connect the
~~~~~~~
. . . . . . . . . . . . . . ..:.. .::.:... ::. :: .i i. i
::.:.:... :,. .
devices h turn to PORT 2, md use the
: .-.... :Ai_
jj&#&$$ t .) &&!j$
.. . . .. . . . . . . . . :.
9
. . . . . . . ..~.........-......~.....~............~~...........
;,.,..,,......;;;._,.~.~~~., ___ ?
md ~~~~~ ““““““. ....“‘...’
2. :#$s’ softkeys
lb compute the reflection correction coefficients, press:
‘lb start the transmis
f&n portion of the come&ion, press: ~~~~~~~~~~~~,
Make a “through” connection between the points where you will connect
your device under test as shown in F’igure 11-l.
Note
Include any adapters or cables that you will have in the device
measurement. That is, connect the standard device where you
will connect your device under test.
ErrorTerms 11-5