HP 8753E - Page 433

The analyzer displays the corrected measurement trace. The analyzer
also shows the notation Cor at the left of the screen, indicating that
error-correction is on.
Note
You can save or store the measurement correction to use for
later measurements Use the menus under @JEGi$ or refer
to “Printing, Plotting, and Saving Measurement Results” located
in the HP 87533 Network Anulgger User’s cui&e for procedures.
18. This completes the full two-port correction procedure. You can connect and
measure your device under test.
‘lhble 11-l. Calibration CoefKcient ‘lkrms and lksts
calibration
Coellleient
calibratioll lhbE
-PO-
l-pert
and Isolation*
xkst
2-pod
NUDlbC?r
1
&i or%
Ex (ED) ED EDF
32
2
ET (Ed
ES
ESF
33
3
ER
ERF
34
4
EXF
36
6
ELF
36
6
ETF
37
7
JbR
33
3
‘%R
30
0
ERR
40
10
EXR
41
11
ELR
42
12
&l?R
43
WYrEsi
Kenning oflirst subscript: D-directivity; S-source match, R-reflection tracking; X-crosstalk;
L-load match; T-transmission tracking.
bleaning of second mhcripk F-forward; R-reverse.
t Response and Isolation cal yields: EX or & if a transmiwion parameter (621, 612) or ED or ER if a
Hlection parameter (%I, 622).
1 One-path,
2-port cal duplicates
array8 1 to 6 in 8lT8yB
7 to 12.
Error Terms
1 l-7