2.
3.
4.
5.
6.
Connect the equipment as shown in
Figure
2-l.
Let the analyzer warm up
for one hour
HP
8753E
NETWORK ANALYZER
Figure 2-1. System Verification
‘l&t
Setup
While
the equipment is warming up, review the “Connector Care Quick
Reference” information in Chapter 1. Good connections and clean,
undamaged connectors are
criticaI
for accurate measurement results.
Insert the verification kit disk into the analyzer disk drive.
Note
If you switch on the record function, you
CAiWOT
switch it off
during the verification procedure.
7. Position the paper in the printer so that priuting starts at the top of the
page.
2-10
System Verification and
Performance Tests
To Next Page
Loading...
