Front Panel Assembly
Tools
Required
n
T-10
TORX screwdriver
n
T-15
TORX screwdriver
n
small slot screwdriver
n
ESD (electrostatic discharge) grounding wrist strap
n
5/16-inch open-end torque wrench (set to 10 in-lb)
Removal
1.
Disconnect
the power cord.
2. Remove the front bottom feet (item 1).
3. Remove
all
of the RF cables that are attached to the front panel (item 2).
4. Remove the line button (item 6).
5. Remove the trim strip (item 3) from the top edge of the front frame by
prying under the strip with a small slot screwdriver.
6. Remove the six screws (item 4) from the top and bottom edges of the frame.
7. Slide the front panel over the test port connectors
8. Disconnect the ribbon cable (item 5). The front panel is now free from the
.
mstrument.
Replacement
1. Reverse the order of the removal procedure.
Note
When reconnecting semirigid cables, it is recommended that the
connections be torqued to 10 in-lb.
14-8 Assembly Replacement and Post-Repair Procedures
To Next Page
Loading...
