HP 8753E - Page 597

INSUFFICIENT MEMORY, PWR
MTR CAL OFF, lo-53
NO CALIBRATION CURRENTLY IN
PROGRESS, lo-53
NO IF FOUND: CHECK R INPUT
LEVEL, lo-54
NO PHASE LOCK: CHECK R INPUT
LEVEL, 19-54
NO SPACE FOR NEW CAL. CLEAR
REGISTERS, 19-54
NOT ALLOWED DURING POWER
METER CAL, lo-55
NOT ENOUGH SPACE ON DISK
FOR STORE, lo-53
OVERLOAD ON INPUT A, POWER
REDUCED, lo-55
OVERLOAD ON INPUT B, POWER
REDUCED, lo-55
OVERLOAD ON INPUT R, POWER
REDUCED, lo-55
PARALLEL PORT NOT AVAILABLE
FOR COPY, lo-56
PARALLEL PORT NOT AVAILABLE
FOR GPIO, lo-55
PHASE LOCK CAL FAILED, lo-56
PHASE LOCK LOST, lo-56
POSSIBLE FALSE LOCK, lo-57
POWER METER INVALID, lo-57
POWER METER NOT SETTLED,
lo-57
POWER SUPPLY HOT!, lo-57
POWER SUPPLY SHUT DOWN!,
lo-57
POWER UNLEVELED, lo-58
PRINTER: error, 10-58
PRINTER: not handshaking, 10-58
PRINTER: not on, not connected,
wrong addrs, lo-58
PROBE POWER SHUT DOWN!,
19-58
PWR MTR: NOT ON/CONNECTED
OR WRONG ADDRS, lo-59
SAVE FAILED. INSUFFICIENT
MEMORY, lo-59
SELF TEST #II FAILED, lo-59
SOURCE POWER TURNED OFF,
RESET UNDER POWER MENU,
lo-59
SWEEP MODE CHANGED TO CW
TIME SWEEP, lo-60
TEST ABORTED, lo-60
TROUBLE! CHECK SETUP AND
START OVER, lo-60
WRONG DISK FORMAT, INITIALIZE
DISK, lo-60
error-correction procedure, 1 l-3
error message for phase lock, 7-4
error messages, 10-1, 10-50
error messages for receiver failure,
8-3
error term inspection, 9-3
error terms, 11-l
directivity (EDF and EDR), 11-11
isolation (crosstaik, EXF and EXR),
11-14
load Match (ELF and ELR), 11-15
reflection Tracking (ERF and ERR),
11-13
source match (ESF and ESR), 11-12
transmission tracking (ETF and
ETR), 11-16
E-terms, 1 l-l
external source, l-3
external source mode frequency
range, 2-21
external tests, 193,10-11
EXTERNAL TESTS, 19-4
F
failure
Index-9