HP 8753E - Page 602

DISK: not on, not connected, wrong
addrs, lo-52
DISK READ/WRITE ERROR, lo-53
error, 10-50
INIWON FAILED, lo-53
NO CALIBRATION CURRENTLY IN
PROGRESS, lo-53
NO IF FOUND: CHECK R INPUT
LEVEL, lo-54
NO PHASE LOCK: CHECK R INPUT
LEVEL, lo-54
NO SPACE FOR NEW CAL. CLEAR
REGISTERS, 10-54
NOT -WED DURING POWER
METER CAL, lo-55
NOT ENOUGH SPACE ON DISK
FOR STORE, lo-53
OVERLOAD ON INPUT A, POWER
REDUCED, lo-55
OVERLOAD ON INPUT B, POWER
REDUCED, lo-55
OVERLOAD ON INPUT R, POWER
REDUCED, lo-55
PARALLEL PORT NOT AVAILABLE
FOR COPY, lo-56
PARALLEL PORT NOT AVAILABLE
FOR GPIO, lo-55
PHASE LOCK CAL FAILED, lo-56
PHASE LQCK LOST, lo-56
POSSIBLE FALSE LOCK, lo-57
POWER METER INVALID, lo-57
POWER METER NOT SETTLED,
lo-57
POWER SUPPLY HOT!, lo-57
POWER SUPPLY SHUT DOWN!,
lo-57
POWER UNLEVELED, lo-58
PRINTER: error, 10-58
PRINTER: not handshaking, 10-58
PRINTER: not on, not connected,
wrong addrs, lo-58
PROBE POWER SHUT DOWN!,
lo-58
PWR MTR: NOT ON/CONNECTED
OR WRONG ADDRS, lo-59
SAVE FAILED. INSUFFICIENT
MEMORY, lo-59
SELF TEST #n FAILED, lo-59
SOURCE POWER TURNED OFF,
RESET UNDER POWER MENU,
lo-59
SWEEP MODE CHANGED TO CW
TIME SWEEP, lo-60
TEST ABORTED, lo-60
TROUBLE! CHECK SETUP AND
START OVER, lo-60
WRONG DISK FORMAT, INITIALIZE
DISK, lo-60
message for phase lock error, 7-4
messages
error, 10-l
meter (power), l-3
microprocessor
theory of operation, 12-3
microwave connector care, l-5
minimum loss pad, l-4
minimum R channel level, 2-31
mnemonic definitions, 10-48
mnemonics for service keys, 10-l
monitor ABUS node 16 for power,
4-15
motherboard check, 5-13
N
NO CALIBRATION CURRENTLY IN
PROGRESS, lo-53
nodes for analog bus, 10-26
NO FILE(S) FOUND ON DISK, lo-54
NO IF FOUND
CHECK R INPUT LEVEL, 7-4,7-38,
lo-54
noise floor level test, 2-37
Index-14