test port output power range and
linearity, 2-27
Unprotected Hardware Option
Numbers Correction Constants,
3-60
verify an analyzer system
(automated), 2-8
pulse generator
source, 12-15
pulse generator
(A7)
check, 7-32
pulses (100
kHz),
7-16
PWR LOSS, 10-5
PWRMTR
NOT ON/CONNECTED OR WRONG
ADDRS,
lo-59
B
range and accuracy of frequency,
2-18
R channel level, 2-31
rear panel
assembly replacement, 1416
digital control, 12-12
part numbers, 13-24-26
Rear Panel, 10-9
rear panel interface
assembly replacement, 14-20
rear panel
LEDs
check, 410
rebuilt-exchange assemblies, 13-3
receiver
digital IF, 12-30
sampler/mixer, 12-29
theory of operation, 12-3, 12-28
receiver check, 416
receiver error messages, 417
receiver
failure
error messages, 8-3
receiver troubleshooting chapter,
8-l
RECORD ON
OFF,
10-5
red LED on
Al5
power supply shutdown, 12-6
REP (4 MHz) signal check, 8-7
reference
source, 12-14
reference,
A12,
10-40
reference
(A12)
check, 7-13
reference frequencies check using
analog bus, 7-13
reference frequencies check using
oscilloscope, 7-15
reference signal (4 MHz), 7-20
reflection Tracking
(ERF’
and ERR),
11-13
REP
signal
At
AllTP9,
7-17
removing
A8,
5-14
line fuse, 5-7
repair procedure, 41
REPEAT ON
OFF,
10-5
replaceable parts,
13-l
abbreviations,
13-48
battery, 13-8
cables, bottom, 13-12
cables, front, 13-14
cables, rear, 13-16
cables, source, 13-18
cables, top, 13-10
chassis, inside,
13-44
chwis,
outside,
13-42
documentation,
13-46
ESD supplies, 1347
front panel, inside, 13-22
front panel, outside, 13-20
fuse, preregulator,
1340
fuses, post regulator,
13-47
fuses, rear panel, 13-24
handles,
13-47
hardware, bottom, 13-30
hardware, disk drive support, 13-36
hardware, front, 13-32
hardware, memory deck, 13-38
hardware, preregulator,
13-40
Index-18
To Next Page
