HP 8753E - Page 612

YO coil drive check with analog
bus, 7-11
troubleshooting power supply, 5-l
troubleshooting source group
appendix, 7-38
two-port error-correction procedure,
11-3
U
uncorrected performance, 1 l-9
unprotected hardware option numbers
correction constants, 3-60
USE SENSOR A/B, 10-6
V
variable fan circuit, 12-7
VCO (A14) exercise, 7-27
VCO range check frequencies, 7-24
Ver Dev l., 10-12
Ver Dev 2., lCL12
Ver Dev 3., 10-12
Ver Dev 4., 10-12
veriiication cycle, kit re-certification,
2-7
verification kit 7 mm, l-3
verification procedures
post-repair, 3-2, 14-62
verify calibration kit devices, 9-4
voltage indications
post regulator, 12-7
voltages
Al5 preregulator check, 5-10
AS, 5-14
fan, 5-22
front panel probe power, 5-19
YO- and YO+ coil drive voltage
differences with& SOURCE
PLL OFT, 7-13
voltages for post regulator, 5-5
voltmeter, l-3
VRAM bank., lo-15
VRAIWvideo, 10-15
W
warranty explanation, 42
waveform integrity in SRC tune mode,
7-9
wrist strap and cord (antistatic), 14
WRONG DISK FORMAT, INITIALTZE
DISK, lo-60
Y
YO coil drive check with analog bus,
7-11
YO- and YO+ coil drive voltage
differences with& SOURCE PLL
OFT, 7-13
Index-24