44. Replace the open/short combination with the 50 ohm termination (supplied
in the calibration kit).
46. Connect the “open” end of the open/short combination to the analyzer test
port 2.
48. Connect the “short” end of the open/short combination to the analyzer test
port 2.
49. press
~~~~~~~~~.
.,..
. . . . . . . .
~;.......,.......................~.~-
. . . . . .
. . . . . . . .
..-..........~~~.~~...~...~~.
50. Connect the 50 ohm termination to the analyzer test port 2.
52. When the analyzer displays PRESS ‘DONE’ IF FINISHED WITH STD(s) , press
~:~~~~~~~~~:.
*,
i_i
_
i
_
__
.._
_1
,.,.,.,.,.,.,.,.,.,.,.
_
Wait for the message COMPUTING CAL COEFFICIENTS to disappear from the
analyzer display before proceeding to the next step.
53. Connect the equipment as shown in
F’igure
2-30.
HP
0753E
NETWORK ANALYZER
I
I
CABLE
24 INCH
sg618.2
Figure 2-30. Transmission Calibration ‘I&t Setup
System Verification and 2-63
Performance
Tests
To Next Page
Loading...
