HP 8920A - Page 199

199
Chapter 6, Call Processing Subsystem
CALL BIT Screen
Order
This field is used to send an order type mobile station control message on the
forward voice channel to the mobile station. The orders available are:
• Change Power to Power Level 0 - 7
• Maintenance (put the mobile station in maintenance mode)
Alert (alert the mobile station)
MRI (mobile reported interference report, NAMPS system type only)
The Order field is a one-of-many selection field. To send an order to the mobile
station select the
Order field. A list of choices is displayed. Select the desired
order from the
Choices: menu. Once the selection is made, a Mobile Station
Control Message is sent to the mobile station. The
Access annunciator will light
momentarily while the Test Set is sending the mobile station control message.
A mobile station must be actively connected on a voice channel to the Test Set
(that is, the
Connect annunciator lit) before you can attempt to send an order to a
mobile station.
When Authent is set to ON, the Order field is not displayed.
Page
This field is used to initiate a page to the mobile station connected to the Test Set.
The Test Set must be in the active state (that is,
Active annunciator must be lit)
and the
MS Id information field on the CALL CONTROL screen must be correct
before you can attempt to page a mobile station.
[] Page
When lit, the Page annunciator indicates that the mobile station connected to the
Test Set is currently being paged on the forward control channel.
Register
This field is used to initiate a registration of the mobile station connected to the
Test Set. The Test Set must be in the active state (that is, the
Active annunciator
must be lit) before you can attempt to register a mobile station.