556
S:\HP892XX\USRGUIDE\manual\txtscrn.fb
Chapter 23, TX Test Screen
Field Descriptions
Distn
This field displays the percent of distortion. The Distortion measurement is only
for a 1 kHz signaling tone.
Ext TX Key
This field controls a switch at the MIC/ACC connector. Its intended use is to
“key” an external transmitter.
See Also
Figure 146 on page 570
Filter 1 and Filter 2
Filters 1 and 2 select a variety of standard and optional filters. Selecting either
field lists the choices available for that field.
See Also
Chapter 5, "AF Analyzer Screen"
FM Deviation
This is the default measurement for this field. The type of measurement listed here
is dependent on the
AF Anl In settings.
See Also
AF Anl In
field description, on page 552
"Displaying Measurements" on page 57
IF Filter
This field selects the desired IF filter’s bandwidth for modulated signals being
analyzed.
To Next Page
Loading...
