HP 8920A - Page 624

Index
624
B
B/I Delay (FOCC)
Signaling Encoder screen, AMPS-
TACS mode, 357
Signaling Encoder screen, NAMP-
NTAC mode, 357
backspace key, 583
bandwidth
adjacent channel power, 92
IF filter, 349, 475, 556
resolution, ACP measurement, 96
Base Freq
Configure screen, 255
base settings
changing, 79
default, 79
base station receiver
simulating, AMPS-TACS/NAMPS-
NTACS, 271
basic operation, 53
Batt Save
Signaling Encoder screen, NMT mode,
424
Battery
memory card, 74
part numbers, 74
replacing, 74
battery, 51, 260
saving, 424
baud rate, 441
beat frequency, 62
Beeper
Configure screen, 51, 257
beeper
error alert, 257
volume control, 51, 257
Bell
radio standard, 380
bias
dc, offsetting, 488
billing information, 429
bit error, 374
bits
CDCSS data rate, 281
CDCSS data stream, 372
CDCSS sequence, 281
digitial paging data rate, 286
dotting, 360, 362
information, 360, 362
LTR data rate, 306
message, 279
NMT data rate, 425
parity, 279, 360, 362, 363
serial data word, 439
specifying patter to display, 275
sync word, 279
triggering, 275
type, 360, 362
word sync, 360, 362
block diagram
AF Analyzer, 101
Duplex Test screen, 341
RF Analyzer, 473
RF Generator, 485
RX Test, 495
TX Test, 551
brightness
setting, 50, 259
BS
definition, 316
BS Identity
Signaling Encoder screen, NMT mode,
424
BSChalOrd
CALLP, 166
buffer overflow error, 287
Bursts
Signaling Encoder screen, AMPS-
TACS mode, 357
Signaling Encoder screen, CDCSS
mode, 369
Signaling Encoder screen, Digi Page
mode, 374
Signaling Encoder screen, DTMF
mode, 379
Signaling Encoder screen, LTR mode,
397
Signaling Encoder screen, NAMP-
NTAC mode, 357
Signaling Encoder screen, Tone Seq
mode, 433
busy state, 357
Busy/Idle
Signaling Encoder screen, AMPS-
TACS mode, 357
Signaling Encoder screen, NAMP-
NTAC mode, 357