3-37
Troubleshooting
ESG Series Signal Generator Instrument-Specific Error Messages
-250 Mass storage error; EEPROM write timeout on
<filename>.
Indicates that the system was not able to program new data to
an EEPROM. The system is still functional, but files written to
EEPROM (such as updated calibration data) may be lost when
the instrument’s line power is cycled. Contact the nearest HP
Sales and Service office.
-253
Corrupt media;User File System
Indicates that the main memory area used for storing
instrument states and sequences as well as other data files is
corrupt. The system will automatically clear and reconfigure
this memory area. A potential cause is a failing backup battery.
Another potential cause could be the loss of line power to the
instrument in the middle of a write operation.
Corrupt media;<media_name>
Indicates that a source media (possibly EEPROM) for a data
file is corrupt. This error is usually seen in conjunction with
errors concerning a certain file.
-254
Media full; Unable to delete saved state from
non-volatile memory. No instrument state
change.
Indicates that the state memory subsystem STATE: was unable
to delete a register. You must free some memory by deleting a
file or register using Catalog. Afterwards, try again.
Media full; Save a state register ignored.
Indicates that the state memory subsystem STATE: did not
have enough room to save a register. You must free some
memory by deleting a file or register using Catalog.
Afterwards, try again.
Media full; Save a state register failed. State
marked available.
Indicates that the state memory subsystem STATE: did not
have enough room to save a register, so the register was lost
and is now marked available. You must free some memory by
deleting a file or register using Catalog. Afterwards, try again.
To Next Page
Loading...
