3-38
Troubleshooting
ESG Series Signal Generator Instrument-Specific Error Messages
-256 File name not found;The internal list file was
not found. There is no list data to return
Indicates that the DWEL_FILE, FREQ_FILE, or POW_FILE has
been lost, so a new one will have to be created. These files are
the persistent information for list/sweep mode. They contain
the dwell list, the frequency list, or the power list. Invoking the
list editor will recreate the missing file to a length of one
element.
-257
File name error;Delete empty sequence
<sequence_name>. Delete sequence ignored.
Indicates that the user has attempted to delete a sequence which
is empty (all registers unused). This is informational only.
Typically this error is reported (several times) when the “Delete
All Sequences” command is executed.
File name error;Delete a non-saved state
register. Delete register ignored.
Indicates that the user has attempted to delete a state which is
empty (unused). This is informational only.
File name error;Directory does not support
extenders.
Indicates that an extender, which is specified by an @ sign
followed by a memory subsystem name, has been specified for
an explicit memory subsystem which does not allow the
@
notation. Only the default
(:) memory subsystem allows
extenders.
File name error;Empty filename
Indicates that a filename of “ “ was specified. This is not a
legal filename.
File name error;Illegal extender
Indicates that an illegal memory subsystem name was used
after the
@. Supported values are @STATE and @LIST.
File name error;Illegal filename character
Indicates that an illegal character was used within a filename.
\, :, @ and all non-printable ASCII characters are illegal in
filenames.
To Next Page
Loading...
