77
(d) The menu below is displayed. Select the signal processing you want to set by turning
[JOG DIAL], and then press the [JOG DIAL] or [ACQ/ENT] key to determine the setting.
You can select the settings of signal processing as shown below.
OFF : Off
STAND : Use for standard situation
COAST : Use for coast navigation
DEEPSEA : Use for deep-sea navigation.
FISHNET : Use for detecting fish nets.
STORM : Use for storm weather.
CALM : Use for calm weather.
RAIN : Use for strong rain/snow.
BIRD : Use for detecting birds flying on the sea.
LONG : Use for detecting weak targets in longrange.
BOUY : Use for detecting the radio bouy.
USER1 : Set it as free uses other than the above.
USER2 : Set it as free uses other than the above.
MODE COAST
COAST
TRAILS >
PULSE LENGTH >
INITIALIZE >
STANDARD
4. Initializing the setting of a function key (Returning to the factory setting)
If you are confused making various settings or want to make a new setting, you can return the
current setting to the factory setting for each function mode.
Take the following
Take the following Take the following
Take the following steps to initialize the setting of a function key:
steps to initialize the setting of a function key:steps to initialize the setting of a function key:
steps to initialize the setting of a function key:
(a) Take steps (a) and (b) in 3 above, select INITIALIZE , and then press the [JOG DIAL] or
[ACQ/ENT] key.
(b) The menu below is displayed. Select YES , and then press the [JOG DIAL] or
[ACQ/ENT] key to determine the selection.
INITIALIZE THIS
FUNCITON SETTING
ARE YOU SURE?
NO
YES
LOAD
Only the above items can be set in the FUNCTION menu. All the other menus are only for
confirming the settings. The following shows FUNCTION menu lists:
To Next Page
Loading...
Need help?
General
