65
3.5.15 Suppressing the power consumption of the radar [MENU]
Use the intermittent transmitting function to suppress the power consumption.
The transmitting state and standby state are automatically switched while the intermittent
transmitting function is used.
The intermittent transmitting function can freely set the periods of the transmitting state and
standby state.
Period of the tran
Period of the tranPeriod of the tran
Period of the transmitting state
smitting state smitting state
smitting state →
→→
→ Set the number of times the antenna rotated.
Set the number of times the antenna rotated. Set the number of times the antenna rotated.
Set the number of times the antenna rotated.
Period of the standby state
Period of the standby state Period of the standby state
Period of the standby state →
→→
→ Set the time while the standby state is placed.
Set the time while the standby state is placed. Set the time while the standby state is placed.
Set the time while the standby state is placed.
1. Using the intermittent transmitting function [MENU]
Take the following steps to use the intermittent transmitting function:
(a) Press the [MENU] key to display MENU .
(b) Select TX PLAN and then TX PLAN pressing the [JOG DIAL] or [ACQ/ENT] key
after each selection.
(c) The menu below is displayed. Turn [JOG DIAL] to select ON , and then press the [JOG
DIAL] or [ACQ/ENT] key to determine the selection.
TX PLAN OFF
OFF 10 SCAN
ON 3 MIN
TX PLAN
When the intermittent transmitting function is turned ON, the transmitting state is placed
only while the antenna rotates the preset number of times. Similarly, the standby state is
placed only during the set time.
2. Canceling the intermittent transmitting function [MENU]
In step (c) above, select OFF , and then press the [JOG DIAL] or [ACQ/ENT] key to determine
the selection.
Caution
●
●●
● Cancelling is possible only when it is under transmitting state. It is not possible
under standby state.
3. Setting the period of the transmitting state (the number of antenna rotations) [MENU]
Take the following steps to set the number of antenna rotations:
(a) Press the [MENU] key to display MENU .
(b) Select TX PLAN and then TX PERIOD pressing the [JOG DIAL] or [ACQ/ENT] key
after each selection.
(c) The menu below is displayed. Turn [JOG DIAL] to set the number of antenna rotations
for placing the transmitting state, and then press the [JOG DIAL] or [ACQ/ENT] key to
determine the setting.
To Next Page
Loading...
Need help?
General
