175
8. GPS receiver master reset [MENU]
This function sends master reset to a GPS receiver and initializes the GPS receiver.
Normally, customers need not set this information.
Normally, customers need not set this information.Normally, customers need not set this information.
Normally, customers need not set this information.
Use the following procedure to send Master Reset.
Use the following procedure to send Master Reset.Use the following procedure to send Master Reset.
Use the following procedure to send Master Reset.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , GPS SETTING , MASTER RESET and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select ON using [JOG DIAL]. TX COMMAND
described in Item 9 is automatically starts and the setting of master reset is sent to the
GPS receiver. The procedure is completed when "COMPLETE!" is displayed. If
transmission fails, "TX FAILED!" is displayed. In this case, start the procedure from (a)
again.
Note
The setting that was set to ON in (b) is reset automatically to OFF after transmission of TX
COMMAND.
POSITION N 36°36.000'
E136°36.000'
ANTENNA HEIGHT 10M
GEODETIC DATUM WGS-84
FIX MODE AUTO
HDOP LEVEL 10
AVERAGE MANUAL 2S
EXCLUDE SAT 00 00 00
MASTER RESET 00 00 00
OFF
ON
GPS SETTING
9. Sending updated set values [MENU]
This function sends the information from item 1 to item 8 that is set in GPS to a GPS receiver.
The values set in items 1 to 8 are not set in the GPS receiver unless this transmission
operation is performed even if the values are changed on the menu.
Use the following procedure to set a prohibited satellite number.
Use the following procedure to set a prohibited satellite number.Use the following procedure to set a prohibited satellite number.
Use the following procedure to set a prohibited satellite number.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , GPS SETTING , TX COMMAND and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed and transmission starts, message "TRANSMIT ..."
is displayed. When transmission is completed successfully, "COMPLETE!" is displayed.
If transmission fails, "TX FAILED!" is displayed. In this case, start the procedure from
(a) again.
To Next Page
Loading...
Need help?
General
