JRC JMA-5104 - Setting a Close Range Dynamic Range [MENU]

162
(i) Adjust the main bang suppression level by turning [JOG DIAL] and erase the main bang.
After completion of adjustment of the suppression level, end the operation by pressing
[JOG DIAL] or [ACQ/ENT].
Ｍ
ＭＭ
ＭＢ
ＢＢ
ＢＳ
ＳＳ
ＳＬ
ＬＬ
ＬＶ
ＶＶ
ＶＬ
ＬＬ
Ｌ
1
11
12
22
28
88
8
Consequently, the main bang suppression level has been adjusted.
(j) Select MBS RNG by turning [JOG DIAL], set the main bang erasing range and end the
operation by pressing [JOG DIAL] or [ACQ/ENT].
(k) Adjust and set the main bang suppression range by turning [JOG DIAL] and end the
operation by pressing [JOG DIAL] or [ACQ/ENT].
Ｍ
ＭＭ
ＭＢ
ＢＢ
ＢＳ
ＳＳ
ＳＲ
ＲＲ
ＲＮ
ＮＮ
ＮＧ
ＧＧ
Ｇ
1
11
12
22
28
88
8
Consequently, the main bang suppression range has been adjusted.
9.8.4 Setting a close range dynamic range [MENU]
Set a range for changing a close range dynamic range. A range from 0.0 to 3.3 miles can be set.
Use the following procedure to set a close range dynamic range.
Use the following procedure to set a close range dynamic range.Use the following procedure to set a close range dynamic range.
Use the following procedure to set a close range dynamic range.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
RADAR , RADAR ADJUST2 , and DR NEAR RNG. , and press [JOG DIAL] or
[ACQ/ENT].
(b) Adjust the main bang suppression level by turning [JOG DIAL] and erase the main bang.
After completion of adjustment of the suppression level, end the operation by pressing
[JOG DIAL] or [ACQ/ENT].