69
Caution
●
●●
● An alarm level 0 to 15 can be set as the volume of the alarm. As a lower value is
specified, the alarm responds to a weaker target.
Be careful that if a set alarm level is too high, the alarm may not work when it
should.
3.5.17 Resetting an alarm (stopping a warning) [ALARM ACK]
This section explains how to stop the alarm when an alarm is issued as a warning.
Stopping the alarm
Press [ALARM ACK] key.
The alarm stops.
3.5.18 Displaying parallel line cursors [MENU], [VRM], [EBL]
Parallel line cursors are displayed across the whole PPI display.
When parallel line cursors are displayed, VRM2 and EBL2 are used to set the turning angle and
the spacing of parallel line cursors.
Displaying parallel line cursors
Take the following steps to display parallel line cursors:
(a) Press the [MENU] key to display MENU .
(b) Select DISP OPTIONS and then PARALLEL LINE pressing the [JOG DIAL] or
[ACQ/ENT] key after each selection.
(c) The menu below is displayed. Turn [JOG DIAL] to select ON , and then press the [JOG
DIAL] or [ACQ/ENT] key to determine the selection.
EBL BEARING TRUE
FROATING EBL OFF
PARALLEL LINE OFF
OFF NM
ON NM
WAYPOINT OFF
POSITION LL
LL-TD CONV>
DISP OPTIONS
The parallel line cursors turn in the direction in which EBL2 turns.
The spacing of parallel line cursors can be changed in the direction in which VRM2 turns.
To Next Page
Loading...
Need help?
General
