127
When you directly connect with the ship's power supply without using the optional
rectifier, measure the voltage between the hull's earth and the positive side of
ship's power spply, and the hull's earth and the negative side of this. And check
voltage of 50 volts or more is not required.
If voltage of 50 volts or more is required, take the measures which do not require
50 volts or more between the above mentioned terminals.
Connection without taking the measures causes system failure or accident.
Caution
●
●●
● Incorrect connection between the ship's power supply or the rectifier and the
power cable may cause an equipment failure.
Inset cable CFQ-6911-5 into
processing unit J1.
To Next Page
Loading...
Need help?
General
