IV
Make sure that the main power is turned off before maintaining the
equipment.
In particular, when a rectifier is used, a voltage is output from the rectifier
even if the power of the display is turned off and the radar is stopped.
If maintenance work is performed without turning off the main power, there is
a risk of equipments breaking down, and dying or getting a serious injury of
any person by electric shock.
When checking a scanner unit for maintenance, make sure that the main
power is turned off and the safety switch attached to the scanner unit is se to
OFF.
If the power is not turned off, there is a risk of equipments breaking down, and
dying or getting a serious injury of any person may occur by electric shock.
And if the rotating scanner unit is touched, there is a risk of equipments
breaking down, and dying or getting a serious injury of any person by electric
shock.
To Next Page
Loading...
