Juniper EX2200 - Chapter 10 Connecting the Switch; Connecting Earth Ground to an EX Series Switch

Unsupported Statements in the [edit interfaces ae] Hierarchy Level
All statements in the [edit interfaces ae] hierarchy level that are displayed in the
command-line interface (CLI) on the switch are supported on the switch and operate
as documented with the following exceptions:
Table 32: Unsupported [edit interfaces ae] Configuration Statements for EX Series Switches
HierarchyStatement
[edit interfaces ae]stacked-vlan-tagging
[edit interfaces ae aggregated-ether-options lacp]admin-key
[edit interfaces ae aggregated-ether-options lacp]system-id
[edit interfaces ae unit]layer2-policer
[edit interfaces ae unit]native-inner-vlan-id
[edit interfaces ae unit]swap-by-poppush
[edit interfaces ae unit]vlan-id-range
[edit interfaces ae unit]vlan-tags
[edit interfaces ae unit family]mpls
[edit interfaces ae unit family]vpls
[edit interfaces ae unit family ethernet-switching]bridge-domain-type
[edit interfaces ae unit family ethernet-switching]inner-vlan-id-list
[edit interfaces ae unit family ethernet-switching]vlan-rewrite
[edit interfaces ae unit family inet]policer
[edit interfaces ae unit family inet]sampling
[edit interfaces ae unit family inet]service
[edit interfaces ae unit family inet]simple-filter
[edit interfaces ae unit family inet]targeted-broadcast
[edit interfaces ae unit family inet]unnumbered-address
[edit interfaces ae unit family inet address vrrp-group track interface]bandwidth-threshold
113Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements