Options See Table 40 on page 178 for protocol families available on the switch interfaces. Different
protocol families support different subsets of the interface types on the switch.
Interface types on the switch are:
• Aggregated Ethernet (ae0)
• 40-Gigabit Ethernet (et)
• Gigabit Ethernet (ge)
• Interface-range configuration (interface-range)
• Loopback (lo0)
• Management Ethernet (me0)
• Integrated Routing and Bridging (IRB) interfaces (IRB) (irb)
• Virtual management Ethernet (vme)
• 10-Gigabit Ethernet (xe)
If you are using an interface range, the supported protocol families are the ones supported
by the interface types that compose the range.
Not all interface types support all family substatements. Check your switch CLI for
supported substatements for a particular protocol family configuration.
Table 40: Protocol Families and Supported Interface Types
Supported Interface Types
DescriptionFamily xevmeme0lo0irbgeetae0
✓✓✓✓Circuit cross-connect protocol
family
ccc
✓✓✓✓Ethernet switching protocol familyethernet-
switching
✓✓✓✓✓✓✓✓IPv4 protocol familyinet
✓✓✓✓✓✓✓✓IPv6 protocol familyinet6
✓✓✓✓✓✓✓✓Junos OS protocol family for IS-IS
traffic
iso
The remaining statements are explained separately.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Copyright © 2015, Juniper Networks, Inc.178
Network Interfaces for EX4300 Switches
To Next Page
Loading...
