Juniper EX2200 - [Edit Chassis] Configuration Statement Hierarchy on EX Series Switches; Supported Statements in the [Edit Chassis] Hierarchy Level

•
periodic on page 215
•
preferred on page 216
•
primary (Address on Interface) on page 217
•
proxy-arp on page 218
•
rpf-check on page 219
•
speed (Ethernet) on page 220
•
traceoptions (Individual Interfaces) on page 221
•
traceoptions (Interface Process) on page 223
•
transmit-interval (Liveness Detection) on page 224
•
traps on page 225
•
unit on page 226
•
vlan (802.1Q Tagging) on page 227
•
vlan-id (VLAN Tagging and Layer 3 Subinterfaces) on page 228
•
vlan-tagging on page 229
[edit chassis] Configuration Statement Hierarchy on EX Series Switches
This topic lists supported and unsupported configuration statements in the [edit chassis]
hierarchy level on EX Series switches.
•
Supported statements are those that you can use to configure some aspect of a
software feature on the switch.
•
Unsupported statements are those that appear in the command-line interface (CLI)
on the switch, but that have no effect on switch operation if you configure them
•
Not all features are supported on all switch platforms. For detailed information about
feature support on specific EX Series switch platforms, see EX Series Switch Software
Features Overview.
This topic lists:
•
Supported Statements in the [edit chassis] Hierarchy Level on page 105
Supported Statements in the [edit chassis] Hierarchy Level
The following hierarchy shows the [edit chassis] configuration statements supported on
EX Series switches:
chassis {
aggregated-devices {
ethernet {
device-count number;
lacp {
link-protection non-revertive;
system-priority system-priority-number
}
}
}
105Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements