Juniper EX2200 - Unsupported Statements in the [Edit Interfaces Me] Hierarchy Level; Table 38: Unsupported [Edit Interfaces Me] Configuration Statements for EX

address interface-address;
mtu bytes;
}
family mpls {
mtu bytes;
}
swap-by-poppush;
(traps | no-traps);
vlan-id vlan-id-number;
}
vlan-tagging;
}
}
Unsupported Statements in the [edit interfaces me] Hierarchy Level
All statements in the [edit interfaces me] hierarchy level that are displayed in the
command-line interface (CLI) on the switch are supported on the switch and operate
as documented with the following exceptions:
Table 38: Unsupported [edit interfaces me] Configuration Statements for EX Series Switches
HierarchyStatement
[edit interfaces me]encapsulation
[edit interfaces me]link-mode
[edit interfaces me unit]encapsulation
[edit interfaces me unit]layer2-policer
[edit interfaces me unit]native-inner-vlan-id
[edit interfaces me unit]vlan-id-list
[edit interfaces me unit]vlan-id-range
[edit interfaces me unit family]ccc
[edit interfaces me unit family]tcc
[edit interfaces me unit family]vpls
[edit interfaces me unit family inet]no-redirects
[edit interfaces me unit family inet]policer
[edit interfaces me unit family inet]sampling
[edit interfaces me unit family inet]service
[edit interfaces me unit family inet]unnumbered-address
143Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements