aggregated-ether-options
Syntax aggregated-ether-options {
ethernet-switch-profile {
tag-protocol-id;
}
(flow-control | no-flow-control);
lacp {
(active | passive);
admin-key key;
periodic interval;
system-id mac-address;
}
(link-protection | no-link-protection);
link-speed speed;
local-bias;
logical-interface-fpc-redundancy;
(loopback | no-loopback);
minimum-links number;
system-priority
}
Hierarchy Level [edit interfaces aex]
Release Information Statement introduced in Junos OS Release 9.0 for EX Series switches.
Statement introduced in Junos OS Release 12.3R2.
Description Configure the aggregated Ethernet properties of a specific aggregated Ethernet interface.
The remaining statements are explained separately.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Example: Configuring Aggregated Ethernet High-Speed Uplinks Between an EX4200
Virtual Chassis Access Switch and an EX4200 Virtual Chassis Distribution Switch
• Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between an
EX4200 Virtual Chassis Access Switch and an EX4200 Virtual Chassis Distribution Switch
• Configuring Aggregated Ethernet Links (CLI Procedure) on page 82
• Configuring Aggregated Ethernet LACP (CLI Procedure) on page 86
• Configuring LACP Link Protection of Aggregated Ethernet Interfaces (CLI Procedure)
on page 87
• Configuring Q-in-Q Tunneling (CLI Procedure)
• Junos OS Ethernet Interfaces Configuration Guide
159Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements
To Next Page
Loading...
