Juniper EX2200 - Supported Statements in the [Edit Interfaces Ge] Hierarchy Level

•
Unsupported statements are those that appear in the command-line interface (CLI)
on the switch, but that have no effect on switch operation if you configure them.
•
Not all features are supported on all switch platforms. For detailed information about
feature support on specific EX Series switch platforms, see EX Series Switch Software
Features Overview.
This topic lists:
•
Supported Statements in the [edit interfaces ge] Hierarchy Level on page 120
•
Unsupported Statements in the [edit interfaces ge] Hierarchy Level on page 124
Supported Statements in the [edit interfaces ge] Hierarchy Level
The following hierarchy shows the [edit interfaces ge] configuration statements supported
on EX Series switches.
interfaces {
ge-fpc/pic/port {
accounting-profile name;
description text;
disable;
encapsulation type;
ether-options {
802.3ad {
aex;
(backup | primary);
lacp {
force-up;
port-priority number;
}
}
(auto-negotiation | no-auto-negotiation);
ethernet-switch-profile {
tag-protocol-id [tpids];
}
(flow-control | no-flow-control);
ieee-802-3az-eee;
(loopback | no-loopback);
no-auto-mdix;
}
flexible-vlan-tagging;
(gratuitous-arp-reply | no-gratuitous-arp-reply);
hold-time up milliseconds down milliseconds;
link-mode {
full-duplex;
}
mtu bytes;
native-vlan-id
no-gratuitous-arp-request;
speed speed;
traceoptions {
flag flag;
}
(traps | no-traps);
Copyright © 2015, Juniper Networks, Inc.120
Network Interfaces for EX4300 Switches