Juniper EX2200 Hardware Guide

vlan-id (VLAN Tagging and Layer 3 Subinterfaces)
Syntax vlan-id vlan-id-number;
Hierarchy Level [edit interfaces interface-name unit logical-unit-number]
Release Information Statement introduced in Junos OS Release 9.2 for EX Series switches.
Description Bind an 802.1Q VLAN tag ID to a logical interface.
NOTE: The VLAN tag ID cannot be configured on logical interface unit 0. The
logical unit number must be 1 or higher.
Options vlan-id-number—A valid VLAN identifier.
Range: 1 through 4094
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• vlan-tagging on page 229
• Example: Configuring Layer 3 Subinterfaces for a Distribution Switch and an Access
Switch
• Configuring Gigabit Ethernet Interfaces (CLI Procedure)
• Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 32
• Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 35
• Configuring a Layer 3 Subinterface (CLI Procedure) on page 97
• Configuring Q-in-Q Tunneling (CLI Procedure)
• Junos OS Ethernet Interfaces Configuration Guide
Copyright © 2015, Juniper Networks, Inc.228
Network Interfaces for EX4300 Switches

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g